CASE STUDY

Billets - Pucks & Slugs: PROJECT FEEDING STEEL BILLETS INTO VARIOUS MACHINES FED

APPLICATION

Model 1500 Feed System for Pucks and Slugs are EXTREMELY flexible and capable of feeding all kinds of different parts. Unlike traditional parts feeders, this feed system can not only handle tubular/solid slugs and pucks in the same feed system, it can handle them GENTLY with no part fallback! If you are machining, forging, grinding, induction hardening or whatever, FEEDALL has your parts feeding problem handled! Since 1946, FEEDALL has provided parts feeding solutions that not only meet, but exceed our customer’s expectations! Contact FEEDALL at 440-942-8100 or visit our website at www.feedall.com to find your local FEEDALL Sales Representative. We look forward to the opportunity to show you how we can not only solve your parts feeding problems, but more importantly, increase your bottom line!

WIDTH

Belt widths vary between 6”, 7-1/2”, 12”, 18”, 24” and 30” on the in-feed (load) side and 6”, 7-1/2”, 12” and 18” wide on the orienting side (depending on your application). Belts are 120#, black PVC with steel clipper lacing and B-section V-guide for positive tracking.

DRIVE

1/2-3 HP, 230/460 volt, 3 phase, 60 hertz, TEFC hi-efficiency Euro-Drive Gear Motor. In-feed lane capacity between 200#-1,500# and orienting lane capacity between 100#- 500#. Drive chain and sprockets totally enclosed by 16 ga. formed steel guards.

FEED RATE

Belt speeds range from 20-100 feet/minute on the in-feed lane and 40-200 feet/minute on the orienting lane. Belt speeds are controlled with variable frequency drives.