Application
Feed from a random loaded floor mounted hopper. The Saw-Cut Steel Billets will be elevated from the hopper via cleated belt and deposited in an end-to end orientation to a transfer device. The parts will be presented and pushed into an Ajax coil, which will hold five parts and have a heat cycle of 50 seconds. The parts will then be pushed one at a time for operator pick-up.
Width
48” Wide Elevating Belt
Drive
1-1/2 HP/AC Motor
Parts Fed (Size)
Saw-Cut Steel Billets (1.38”Ø x 11.75” Lg.)
Feed Rate
360 Parts/Hour